User's Manual

Brand of ACOEM

2.3 WIRELESS SENSOR

Instructions for the first connection are presented in § 1.11.2.

If the communication is bad or not possible, check following points:

 Check if the sensor is switched on and if the blue LED is continuously on (searching for connection) or

flashing (connected to an instrument)

 Check on FALCON if Wi-Fi is enabled in:

Shortcuts > Setting > > Wi-Fi = enabled

 Check if FALCON is set to work with a WLS sensor:

Shortcuts > Setting > > Accelerometer link = Wireless

 Check if the serial number of the sensor is that declared in FALCON

Shortcuts > Setting > Wireless sensor

 Check with a shorter distance and no obstacle between the sensor and the instrument.

 If the connection is OK and the communication is bad, it may be due to another Wi-Fi network using the

same channel. You can try to use another one:

Shortcuts > Setting > Wireless sensor:

o Change the channel number only in case of bad quality transmission

o Select in the list another channel: 1, 6 or 11.

WARNING: WLS sensor firmware version must be at least v1.08.

To update the WLS sensor see § 5.6

o Keep the sensor powered near the device

o Press "Save".

o It will take a few seconds for the sensor to restart on the new channel.

You can also use the test function, it returns:

 The status of the test (Successful or Failed)

 WLS firmware version

 WLS hardware version

 Sensitivity for each of the 3 channels.