User's Manual

41
Brand of ACOEM
3.5.2 Acquisition
The instrument takes in one shot all measurements with the same input type for all the points grouped together.
The channel association rules are explained in § 3.5.8.
Progress bar:
During the acquisition there is a succession of 2 progress bars:
 The acquisition itself:
The bar is yellow; its duration depends on the configuration of the measurement.
When this one is completed you can already remove the sensor.
 The processing:
The bar is white. Most of the processing is performed during the acquisition. The remaining processing
usually does not exceed 2s.
For the machine with automatic diagnosis, a pop-up message appears during diagnosis specific computation.
Display during the acquisition:
You can select the type of display used during the acquisition (see § 2.1).
The selection is:
 Progress-bar only,
 Overall level,
 Spectrum
 Time wave
By default, the 1
st
measurement of the selected type is displayed during the acquisition. To display another
measurement of the same type, select it before the acquisition.
Status information:
The status is indicated at the bottom of the right hand side of the screen
 During analogic acquisition
o Input overload indication in percentage of time
o Sensor integrity indicator
 During wireless measurement
o Sensor overload indication in percentage of time
o Battery level of the sensor
Status message:
If a defect is detected during the acquisition a pop-up message is displayed at the end of the acquisition.
It indicates the status of each channel.