User's Manual

Brand of ACOEM

3.7.5.4 Tab 2 for “Phased spectrum” measurement type:

Tab “Phased spectrum”:

 High-pass filter: None, 2 Hz (120 CPM), 10 Hz (600 CPM)

Note: “None” is not accessible in case of integration:

o Input = accelerometer and parameter = velocity or absolute displacement

o Input = Velocimeter and parameter = absolute displacement

 Frequency range: 40 kHz (2400 kCPM), 20 kHz (1200 kCPM), 10 kHz (600 kCPM), 5 kHz – 300 kCPM), 2

kHz (120 kCPM), 1 kHz (60 kCPM), 500 Hz (30 kCPM), 200 Hz (12 kCPM), 100 Hz(6000 CPM), 50 Hz

(3000 CPM)

 Number of lines: 100, 200, 400, 800, 1600, 3200, 6400

 Number of averages: 1 to 4096

Notes:

o Phased requires a trigger input used as phase reference

o Triggering parameters are defined in the general configuration: see § 2.4

3.7.5.5 Tabs 2 and 3 for “Time wave” measurement type:

Tab “Time wave”:

 High-pass filter: None, 2 Hz (120 CPM), 10 Hz (600 CPM)

Note: “None” is not accessible in case of integration:

o Input = accelerometer and parameter = velocity or absolute displacement

o Input = Velocimeter and parameter = absolute displacement

 Sampling frequency: 204.8 kHz, 102.4 kHz, 51.2 kHz, 25.6 kHz, 12.8 kHz, 5.12 kHz, 2.56 kHz, 1.28 kHz,

512 Hz, 256 Hz

 Number of samples: 256, 512, 1K, 2K, 4K, 8K, 16K, 32K, 64K.

With long time wave option: 128K, 256K, 512K, 1M, 2M and 4M

Limitations:

o If licence = Advanced: 8K max

o If Triggering source ≠ Free: 16K max

o Extended number of samples with long time wave option: up to 80 s split over the number of

channels or 4,096K samples. For more details see § 6.2.2

 Averaging: Linear

 Number of averages: 1 to 4096.

Average number is forced to 1 if Triggering source = Free

Tab “Trigger”:

 Triggering source: Free, Signal, Tachometer

For Tachometer source, triggering parameters are defined in the general configuration: see § 2.4.

For Signal source,

o Wired sensor: triggering is done on channel 2 if triaxial mode is used otherwise on channel 1

o Wireless sensor: triggering is done on sensor Z axis.

 Triggering level: Value in parameter unit

Used if Triggering source = Signal