User's Manual

Brand of ACOEM

4.4.2 Tachometer / Triggering device

In order to measure the phase, an instrument must be installed, that generates an electric pulse at each rotation.

Use following accessories:

 ACC1072000 OPT-TRG-LAS 5V PWS: optical triggering device with laser sighting

 CPC1228000 CABLE ECTC-M12-STR-001.5: 1.5 meter to connect it on FALCON

 CPC1226000 CÂBLE RALLONGE M12 5M: 5 meter cable extension

 850910 OPTAPE: adhesive reflective tape. 1 cm must be installed on the rotor

The optical triggering device must be connected to connector C

The optical triggering device can be installed easily with following accessories:

 ACC1055000 Magnetic support

 ACC1056000 Three-finger clamp

For the setting of the tachometer input see § 2.4.

A pulse is sent to FALCON for each rotation of the machine.

4.5 SETUP

This screen includes 4 tabs. They are used to define the balancing and the type of measurement used to perform

the balancing process.

Values can be directly modified. If some modifications have been made, a confirmation message to save them or

not is asked before going to another screen.

Once the setup is completed, it is possible to:

Go to the next step: Run out measurement if you are using proximity probes (see § 4.6) or Free run in other

cases (see § 4.7)

Go to the steps browser to reach directly any other accessible step (see § 4.11)

Exit: return to balancing test list (see § 4.3)

Notes:

 If some modifications have been made, a confirmation message to save them or not is asked before going

to another screen.

 When a measurement is already done, it is normal that some setting cannot be modified.