User's Manual

20
Brand of ACOEM
3.3. CONNECTION TO THE GATEWAY
The gateway is powered and connected to an IP network by a unique cable (ethernet
category 5e) thanks to a PoE (Power over Ethernet) injector (compliant with 802.11.3af-
2003).
Prior to installation, the site must be equipped with both power and ethernet connections
where the PoE will be installed. A technical cabinet can be necessary. The link to the
customer IP network can be fiber-optic, copper…
No hazardous on-field cabling!
 The ethernet cable must not be connected to the other end.
 The operator has to prevent the occurrence of an ignitable atmosphere (employing the
use of suitable gas detection systems).
Figure 17 . gateway connection
The Ethernet connection to the gateway is tool free.
Use a standard Ethernet Category 5e cable pulled from a technical cabinet (not Step 1.
connected).
IP68 gland is delivered with the gateway housing and has to be mounted on the Step 2.
Ethernet cable before connecting the gateway. Figure 18 describes this procedure.
Plug the assembly in the waterproof Ethernet receptacle located on the back of the Step 3.
gateway.
Ensure that the assembly is fully tighten Step 4.
Figure 18 : Plug assembly instructions
GATEWAY