User's Manual

Brand of ACOEM

CAUTION: Only use your hands or a rubber strap wrench to remove the protection tube from

the sensor/expander. The use of tongue-and-groove pliers (also known as water pump

pliers, adjustable pliers, groove-joint pliers, arc-joint pliers, Multi-Grips, and Channellocks)

are forbidden and will cause damages and lose of sealing IP67.

7. PROTECTIONS

7.1. FALL PROTECTION

Make a sensor/expander tether with a stainless steel lanyard to provide more safety and

avoid to the sensor/expander to fall.

Step 1. Thread a thin cable through the Ø 2 mm hole [Ø 0.078 in] drilled into the

sensor/expander.

Thread the other side of the wire through a fixed object Step 2.

Crimp the loop ends Step 3.

CLIP