User's Manual

www.acoemgroup.com
[e-mail]
Copyright © 2014 - 01dB-Metravib SAS
This document is the property of 01dB-Metravib SAS. Any dissemination, copying or publicising of this document, in whole or in
part, is prohibited without the owner’s written authorisation
5.5. FCC AND IC
5.5.1. Agreement numbers
Table 5: FCC and IC IDs for Eagle devices
Item
Model
FCC ID (USA)
IC (Canada)
Gateway (Int. Antenna)
EGL1101000
2AC3Z-EGL1101
12336A- EGL1101
Gateway (Ext. Antenna)
EGL1105000
Single Axis Sensor
EGL1102000
2AC3Z-EGL1102
12336A-EGL1102
Tri Axis Sensor
EGL1103000
Expander
EGL1104000
Caution: any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
5.5.2. NOTES FCC:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception which can be determined by
turning the equipment off and on, the user is encouraged to try to correct interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF exposure: This device complies with FCC RF radiation exposure limits set forth for
general population. This device must be installed to provide a separation distance of
at least 20cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
5.5.3. NOTES IC:
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
 - The antenna sensors and repeaters is internal and not interchangeable.
 - The antenna of Gateway EGL1101000 is internal and not interchangeable.
 Gateway EGL110500 can be equipped with the following external antenna:
 "Omni Directional WiFi iANT212 Rugged Antenna is Extronics".