Installation manual

Preparing for NFS Authentication
Adding an NFS Access List
CLI Storage-Management Guide 4-23
Removing an Access List
From gbl mode, use the no nfs-access-list command to remove an NFS access list:
no nfs-access-list list-name
where list-name (1-64 characters) identifies the access list to remove.
You must remove all references to the access list before you can use this command to
remove the list itself. An access list is referenced from an NFS service; instructions
for configuring an NFS service appear below.
For example, the following command sequence removes the NFS access list,
“southwest:”
bstnA6k(gbl)# no nfs-access-list southwest
bstnA6k(gbl)# ...