Installation manual

Preparing for CIFS Authentication
Adding an Active-Directory Forest (Kerberos)
3-26 CLI Storage-Management Guide
Focusing On a Single Processor
On an ARX®6000, you can use the optional from clause to focus on a particular
processor:
show active-directory status [forest forest-name | domain
domain-name] from slot.processor
where
forest forest-name and domain domain-name are described above,
from is a required keyword,
slot (1-6) is the slot number of the desired SCM or ASM, and
processor (1-6) is the processor number. Use
show processor for a complete
list of processors (and their modules and slots) on the ARX.
For example, this focuses the earlier output on processor 5.2, an ASM processor:
bstnA6k(gbl)# show active-directory status from 5.2
Processor 5.2:
Transition
Forest Domain Controller Domain Name Status Total
Last (UTC)
------------- ------------------- ---------------------------------------- --------
---- --------------------
vt.com 10.52.140.1 MCNIELS.VT.COM Active 1
08:24:38 11/06/2007
vt.com 10.52.150.1 NH.ORG Active 1
08:24:26 11/06/2007
vt.com 10.52.130.1 VT.COM Active 1
08:24:09 11/06/2007
ny.com 10.52.120.1 CATSKILLS.NY.COM Active 1
08:23:57 11/06/2007
ny.com 10.52.110.1 ADK.NY.COM Active 1
08:23:35 11/06/2007
ny.com 10.52.100.1 NY.COM Active 1
08:23:35 11/06/2007
medarcv 10.19.230.94 BOSTONCIFS.FDTESTNET.NET Active 1
08:23:31 11/06/2007
medarcv 172.16.168.21 FDTESTNET.NET Active 1
08:23:12 11/06/2007