Installation manual

Preparing for CIFS Authentication
Authorizing Windows-Management (MMC) Access
CLI Storage-Management Guide 3-33
Removing a Management-Authorization Group
You can only remove a management-authorization group if it is not referenced by any
namespace. A later chapter describes how to configure a namespace and reference a
management-authorization group.
To remove a management-authorization group, use the
no windows-mgmt-auth
command in gbl mode:
no windows-mgmt-auth name
where name (1-64 characters) identifies the group to remove.
For example, the following command sequence removes a management-authorization
group called “beta:”
bstnA6k(gbl)# no windows-mgmt-auth beta
bstnA6k(gbl)# ...