User Manual

2
water.
• Although the units have been cleaned before leaving factory, we strongly
recommend using a soft cloth dampened with warm water and a little neutral
detergent to clean it again, then wipe it with dry soft cloth. (Warning: Electrical
parts should be wiped by dry cloth only).
• Warning: Do not allow children to play games with the refrigerator such as
climbing or standing in the refrigerator. They could damage the refrigerator and
seriously injure themselves.
3. The Function and Operation Setting
• Power On/Off: Press the Power Button to turn the unit on/off
• Temperature Setting: Can be adjusted by the “+” button up to 20℃ (Max) and
down to -20℃ (Max) by the “- “button; Default temperature is Celsius
degree (C). If you would like to change to Fahrenheit degree (F), turn off
the fridge, press and hold SET button for 3 seconds. E1 should display
on screen and begin flashing; continue to press SET button until E5
shows up, then press △ or ▽, select desired units: F or C.
The compressor will cool down the temperature from 10℃ to -10 ℃ in 20
mins. However, this reflects the change in temperature within the
insulated walls of the fridge/freezer. Allow an additional hour or more
time, depending on the food load, to reach cooling temperature around
1-6 degrees Celsius. To reach freezing with food or beverage inside it
will take approximately 8 hours. Therefore, if you want frozen or chilling
temperatures inside, we suggest you turn on the compressor 10 hours
ahead of time while keeping the temperature setting at -15℃ or lower.
• Cooling Mode Control: Press the button “ ” to select control mode. Short
Press will switch between MAX (Quick cooling mode) and ECO (Energy-saving
mode) (tip: Max mode is recommended to begin initial cool down). After
desired temperature has been attained, it is recommended to switch to ECO
mode to conserve energy cooling mode.
• Battery Protection: Selecting the H, M, L positions, you can choose different
levels for battery protection. When the unit is on and working, press the “ ”
button for 3 seconds, then the LCD will display as below: