PTK-100LCD10A 30m (1.2 in) mm 505 )(19.9 in mm 650 )(25.6 in 14b 14a 14 9a 9b Accessories: (Table 1) 1. Handle 9a. Red Positive Battery Clip 2. Latches 9b. Black Negative Battery Clip 3. Aluminum frame 10. Anderson Plug 4. Aluminum support legs 11. Fuse 5. Solar charge controller 12. Handy carry bag 6. Junction box 13. Corner protector 7. Label 14. MC4 cables 8. Cable 14a. Red Positive MC4 Cable 9. Battery Clips 14b. Black Negative MC4 Cable Power Your Green Life! www.ACOPower.
Introduction This portable solar panel comes with a pre-installed charge controller. This charge controller protects the battery against unsafe electrical conditions and must be used to charge 12V batteries. To charge solar generators with a built-in charge controller, simply use the MC4 cables provided and plug them into the cables that came with your power station to charge. A 12V battery and solar generator can be charged at the same time.
If you’re not getting something within that range or close to those numbers, you should check and make sure the solar panel is in direct sunlight and that the connections between the MC4 cables and the multi-meter is secure.
What are youwww.ACOPower.com going to use it for 1. Charge solar generators 1.1. Charge 12V Solar Generator with built-in Charge Controller Step 1: understand your solar generator and prepare the MC4 adapter for your solar generator Step 2: Disconnect MC4 Connectors and let it to be a solar panel with MC4 connectors Step 3: Use your MC4 Adapter to charge your solar generator 2.
PV Specifications 100w solar panel Specification Type Module Size Max- N.W OpenMaxPower Max-power Short-circuit Power Circuit Voltage Current Current Voltage Module mm 650*505*30 Kg W V 2*50 17.8 A V A 15 2*50w 2*1.8 1 22 .3 2*3.03 (25.6*19.9*1.2 in) (33.1 lb) Charge Controller This solar panel module comes with a 10A solar charge controller which will look like the one shown below.
Wiring Connect all components as shown in “Figure 1: Connections” in this order: 1. Battery 2. Load 3. PV Array () Always connect the battery first. The charge controller does not come with independent power and will not power on without first being supplied power from the battery. This also allows it to recognize the system voltage for proper setup. When disconnecting the system, do in reverse order. () Pay close attention to the polarity “+” and “-“ of your connections.
Load mode Settings () Under load mode setting interface, press SET button and hold for 5s until the number begins flashing. Then press MENU button to set the parameter, press SET to confirm. Refer to Figure 5 below for load modes.
Charge Controller Specifications Refer to the table below for technical specifications of our charge controllers. Item VS1024AU VS2024AU VS3024AU 12/24VDC Auto Nominal system voltage Battery input voltage range Rated charge/discharge current Max. PV open circuit voltage 9V～32V 10A@55℃ VS3048AU VS4524AU 12/24/36/48 VDC Auto 12/24VDC Auto 9V～64V 20A@55℃ 9V～32V 30A@55℃ 50V VS4548AU 12/24/36/ 48VDC Auto 9V～64V 96V 50V 96V Equalize Charging Voltage※ Sealed:14.6V/ Gel: No/ Flooded:14.
Power Your Green Life! FREQUENTLY ASKED QUESTIONS (FAQ) ACOPOWER is always open to customers with technical support, if you have any issues, please feel free to contact ACOPOWER by email at support@acopower.com Here we collected some frequently asked questions for reference: Q. What type of batteries can be used with the kit? A: 1. sealed lead-acid battery (Sealed) 2. colloidal lead-acid battery (Gel) 3.
Power Your Green Life! Q: Can I use my own controller, or can I use MPPT charge controller? A: Yes, if you would like to do so, please remove the charge controller and use the solar panel with MC4 connectors to connect your own controller. Q: I connect the kit with my battery with red clamp to Positive and black clamp to Negative, why wont the charge controller power on? A: We suggest charging your car battery for the kit’s test. Test your solar panel’s open circuit voltage and battery’s voltage.
Power Your Green Life! Warranty Limited Product Warranty-One Years Repair, Replacement and refund Remedy, but fuse excluded The solar panel itself comes with an 18-months workmanship warranty and a 25-year 85% output warranty. Within 30 days of purchase: Items can be returned for a full refund or replacement, we will cover return shipping due to quality issues, buyer pays return shipping and replacement shipping due to non-quality issues.
Thank you for your business and support! ACOPOWER Team technical support: support@acopower.com www.acopower.com Warranty Registration Web Power Your Green Life! www.ACOPower.
