Use and Care Manual

Temperature Setting: Can be adjusted by the “+” button up to 20℃ (Max) and
down to -20℃ (Max) by the “- “button; Default temperature is Celsius degree (F).
If you would like to change to degrees Fahrenheit (F), turn off the fridge, then
press and hold the SET button over 3 seconds. E1 should be displayed on screen
and begin flashing;
continue to press the SET button until E5 shows up, then press + or -, select
desired units: F or C.
The compressor will cool down the temperature from 10℃ to -10 ℃ in 20 mins.
However, this reflects the change in temperature within the insulated walls of the
fridge/freezer. Allow an additional hour or more time, depending on the food load,
to reach a refrigerating temperature around 1-6 degrees Celsius. To reach
freezing temperatures with food or beverage inside the unit will take
approximately 8 hours. Therefore, if you want frozen or chilling temperatures
inside, we suggest you turn on the compressor 10 hours ahead of time while
keeping the temperature setting at -15℃ or lower.
Cooling Mode Control: Press the “ ” button to select control mode. Short
Presses will switch between MAX (Quick cooling mode) and ECO (Energy-saving
mode)
(tip: Max mode is recommended to begin initial cool down). After desired
temperature has been attained, it is recommended to switch to ECO mode to
conserve energy cooling mode.
Battery Protection: Selecting the H, M, L positions, you can choose different
levels for car battery protection. When the unit is on and working, press the “ ”
button over 3 seconds, then the LCD will display as below:
o L: Low power protection 9.0V (factory default)
o M: Middle power 10.1V
o H: High power protection 11.3 V
When the unit is connected to the car, we suggest setting the car battery
protection to H level. L is suggested when the unit is powered with freezer battery
or auxiliary backup battery.
USB Output: +5VDC /2.1A for cell phone, tablet, WIFI speaker, etc.
Note: Don’t change settings on E1-E4, which is only for factory maintenance.
3
•
•
•
•