Thanks for shopping with Improvements®! S/2 WIRELESS SPEAKERS Item #333154 To order, call 1-800-642-2112 West Chester, OH 45069 Made in China If you have any questions or suggestions regarding this product, call Improvements® at 1-800-944-8870 x 214 (M-F 8:00 - 4 EST) or e-mail: productsupport@improvementscatalog.com See many more products on the Internet! www.ImprovementsCatalog.
INTRODUCTION This stereo wireless speaker system applies the latest 900Mhz wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the transmitter with any audio source such as i-pod, TV, DVD, Hi-Fi and CD/MP3 player. A. FEATURES 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.
B. COMPONENT IDENTIFICATION 1. TRANSMITTER Power/Signal indicator (Green/Blue) 2.
3. REMOTE CONTROL UNIT C. INSTALLATION 1. A. B. C. TRANSMITTER Connect the supplied AC power adaptor to an electrical wall outlet. Plug the AC power adaptor in the DC jack located on the rear of the transmitter. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, i-pod, DVD, and CD/MP3 players or to headphone/earphone jack with the connector provided. When the power adapter connection is finished, the LED of transmitter will light up in Green.
B. Press Power button and turn the speakers ON. The Power/Standby LED will light up in Blue. 3. A. B. REMOTE CONTROL UNIT Remove the battery cover at the rear of the remote control unit and insert 2 “AAA” size batteries (not included) into the battery compartment with the correct polarity. Place back the cover and close the battery compartment. D. OPERATION 1. Connect the power adapter between wall jack and transmitter. The LED will turn to Green. 2.
5. Push the “AUTO TUNE” button to get the best tuning reception in the speakers. When the button is pressed, frequency tuning starts automatically and it stops when a signal is detected. 6. You should now be able to place the speakers freely inside or out within 150 feet from transmitter. SWITCHNG OFF 1. If there is no audio input signal to transmitter in 4 minutes, transmitter will go to standby mode and LED will change from Blue to Green. 2.
TECHNICAL CAL SPECIFICATIONS Transmission Mode Carrier Frequency Operation Voltage : : : Frequency Response Distortion S/N Ratio Channel Separation Operation Distance Output Power : : : : : : UHF stereo 900 MHz Transmitter, DC 6V 300mA Speaker, 8 X “C” size Alkaline batteries or DC 12V 750mA adaptor Remote Control Unit, 2 X ‘AAA’ size batteries (not included) 40Hz – 12KHz 1.
Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the user’s authority to operate the equipment. Any change to the equipment will void FCC grant.