User's Manual

5. Push the “AUTO TUNE” button to get the best tuning reception in the speakers. When the button is pressed,
frequency tuning starts automatically and it stops when a signal is detected.
6. You should now be able to place the speakers freely inside or out within 150 feet from transmitter.
SWITCHNG OFF
1. If there is no audio input signal to transmitter in 4 minutes, transmitter will go to standby mode and LED will
change from Blue to Green.
2. If the power adapter is unplugged, the LED on transmitter will turn off.
3. Speaker will turn to standby mode if there is no input signal to transmitter and LED will become Green.
Speaker will automatically shut off when standby mode continues for 5 minutes.
4. Speaker will also turn to standby model if you press the POWER button on the remote control to Green
LED. Speaker will automatically shut off after 5 minutes.
5. At standby mode, speaker will turn to On automatically after getting signal from transmitter.
OTHER CONTROL
1. Select volume up and down on Speakers or Remote Control Unit
2. Select Bass Boost On/OFF by pressing the “BASS BOOST” button on Speakers or Remote Control Unit
3. If you hear interference from other components, re-adjust the tuning control by moving channel knob to 1, 2
or 3 of the transmitter, then pressing “AUTO TUNE” button on speaker or remote unit for best reception.
E.
TROUBLESHOOTING
NO SOUND
- Ensure the AC adaptor is fully inserted into the AC outlet and the power connection input on the
transmitter.
- Ensure the speaker is switch ON.
- Speaker’s battery capacity is too low, replace with new batteries or connect the AC adaptors to the
speakers.
- Ensure the TV or audio component is ON.
- The connected audio / video equipment is not playing. Start playing the equipment.
- The volume of speaker is too low, adjust the volume to an appropriate level.
DISTORTED
- Press the “AUTO TUNE” button on the speakers until matching the frequency of the transmitter.
- Change the position of the channel selector on the transmitter. You must then press the “AUTO
TUNE” button on the speakers.
- Battery capacity is too low. Replace with the new battery.
- Ensure the volume level of speakers is adjusted properly.
- The speaker is too far from transmitter, move closer.
- The input level of the audio signal is too low. Turn up the volume of the audio source equipment.