User's Manual

E. OPERATION

1. Turn on the transmitter. The LED will light up in Green.

2. Turn on the audio source (TV or audio component like an iPod) to which the transmitter is connected. The

LED will change from Green to Blue.

3. Select channel 1, 2 or 3 of the transmitter for best performance in your location.

4. Turn on the Power button on the speaker. Press the Autoscan button. Adjust the volume by pressing “+”

and “-“ for desired listening level.

Caution: Screw the battery door clockwise to tightly close it and to make sure there is no gap before placing the

speaker into the water.

5. Both transmitter and speaker can be powered by power adapters.

SWITCHING OFF

1. If there is no audio input signal to the transmitter for a 4 minute period, the transmitter will go into standby

mode and the LED will change from Blue to Green.

2. If the audio source is off, the LED on the transmitter will change to Green.

3. The Speaker will turn to standby mode if there is no input signal to transmitter and the LED becomes

Green. The Speaker will automatically shut off when standby mode continues for 5 minutes.

4. While in standby mode, the speaker will turn to On automatically after getting a signal from transmitter.

OTHER CONTROL

1. Select volume up and down on Speaker.

2. Select Light button to turn on the mood light effect in the water. This feature works only when the Speaker is