900 MHz WIRELESS SPEAKER BD-9787-N INSTRUCTION MANUAL
INTRODUCTION This stereo wireless speaker system applies the latest 900Mhz wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the transmitter with any audio source such as i-pod, TV, DVD, Hi-Fi and CD/MP3 player. A. PACKAGING 1. RF transmitter 2. RF speakers, 2 pcs. 3. AC adapter for transmitter 4. AC adapters for speaker, 2 pcs. 5. Remote Control 6. 3.5mm to 3.5mm audio cable 7. 3.5mm plug to 2 X RCA audio cable(YCABLE) B.
C. 1. COMPONENT IDENTIFICATION TRANSMITTER Power “ON” indicator 2.
3. REMOTE CONTROL UNIT D. INSTALLATION 1. A. B. C. D. E. TRANSMITTER Connect the supplied AC power adapter to an electrical wall outlet. Plug the AC power adapter in the DC jack located on the rear of the transmitter. Or you can insert 4 X “AA” size ALKALINE batteries into the battery compartment at the bottom of the transmitter with correct polarity.
DC Jack B. 3. Press Power button and turn the speakers ON. The Power/Standby LED will light up in Blue. REMOTE CONTROL A. Remove the battery cover at the rear of the remote control unit and insert 2 pcs “AAA” size batteries (not included) into the battery compartment with the correct polarity. B. Place back the cover and close the battery compartment. E. OPERATION 1. Connect the power adapter between wall jack and transmitter. The LED will turn to Green. 2.
SWITCHING OFF 1. 2. 3. 4. 5. If there is no audio input signal to transmitter in 4 minutes, transmitter will go to standby mode and LED will change from Blue to Green. If the power adapter is unplugged, the LED on transmitter will turn off. Speaker will turn to standby mode if there is no input signal to transmitter and LED will become Green. Speaker will automatically shut off when standby mode continues for 5 minutes.
G. TECHNICAL SPECIFICATIONS Transmission Mode Carrier Frequency Operation Voltage : : : Frequency Response Distortion S/N Ratio Channel Separation Operation Distance Output Power : : : : : : WARNING : UHF stereo 900 MHz Transmitter, DC 6V 2A adapter or 4 X “AA” size Alkaline batteries (not included) Speaker, DC 12V 1.2A adapter or 8 X “C” size Alkaline batteries (not included) Remote Control Unit, 2 X ‘AAA’ size batteries (not included) 50Hz – 12KHz 1.