INSTUDIO BLUETOOTH SPEAKER BS1130TUS BS1130TE 8016810 Instruction Manual
A. INTRODUCTION This Bluetooth wireless speaker system applies the latest BT 2.1 wireless technology platform that enables you to enjoy music, video everywhere you want. B. FEATURES 1. Bluetooth 2.1 Platform 2. Operating distance up to 10 meters / 33 feet (open area) 3. Powered by 6x “C”Size alkaline batteries (not included) or Power adapter 4. IPX 3 Water-proof feature 5. 3.5mm line in jack C. PACKAGING 2 X Bluetooth speakers 2 X 3.5 to 3.
D. COMPONENT IDENTIFICATION 1. Power ON/OFF 2. Power LED Indicator(Red, Blue, Green) 3. Pair 4. Volume 5. Volume+ 6. Power adapter jack 7. 3.5mm audio jack E. General operation: Power on: Press POWER button for 2 seconds. Blue LED will flash quickly two times. Power off: Press POWER button for 2 seconds. Blue LED will flash quickly three times. Switch between Bluetooth and Line in Quick press Power key once, SOLID GREEN LED lights up. Maximum volume : When maximum volume is reached,Red and Blue LED flash.
F. PAIRING (Stereo, play music with two speakers) Connected Connected Bluetooth Device Step 1. Pairing between two speakers 1. Make sure two speakers are powered off. 2. Press and hold the POWER button (approx. 4 seconds) for the first speaker until RED LED flashes. 3. Press and hold the POWER button (approx. 8 seconds) of the second speaker until RED and BLUE LED flash alternatively. 4. Solid RED LED lights up when two speakers are connected. (approx. 12 seconds) Step 2.
. Enter “0000” if password is required. 6. When connected, BLUE LED will flash slowly for the MASTER speaker(Left Channel). RED LED will light up for SLAVE speaker(Right Channel). 7. When playing music, for MASTER speaker(Left Channel) SOLID BLUE LED lights up, for SLAVE speaker (Right Channel) SOLID RED LED lights up. Important Note: When two speakers are connected to the user's bluetooth device, if user tries to search the third bluetooth device around, there will be interference and sound interruption.
I. Line in 1. Connect the speaker with your audio device directly by the supplied 3.5mm cable 2. Quick press POWER button once to swith to line in mode. 3. Green LED lights up. Important note: Line in function only supports MONO mode with one speaker. Battery Installation: 1. Turn the speaker over; on the bottom of the speaker you will see the battery door. 2. Open the battery door by pinching the two tabs and pulling towards you. 3.
TABS Bottom portion of the speaker Insert batteries correct direction J. TECHNICAL SPECIFICATIONS Carrier Frequency Power Requirements : Bluetooth 2.1 : By 6x C size alkaline batteries (not included) Or power adapter Audio Frequency Response : 30Hz – 18KHz Distortion : <1% S/N Ratio : 65dB (typical) Channel Separation : 60dB (Typical) Operation Distance : Up to 10 meters / 33 feet (open area) Audio Output Power : 5W NOTES: This speaker is in compliance with the specified Bluetooth version.
- The volume of speaker is too low; adjust the volume to an appropriate level. - Unable to connect with BlueTooth device, RESET the speaker by pressing and holding the Pair/Battery Check button for 12 seconds. - The speaker may be too far away from the Bluetooth device, move closer to it. THE FCC WANTS YOU TO KNOW Warning! This device complies with Part 15 of the FCC rules.