User's Manual

Wired Headphone Application

The headphone can be applied in corded mode. Simply connect the headphone and the

audio source by the supplied 1.5 meters audio cable. You will then enjoy the audio in

wired mode.

WARNINGS:

** Never use another type of battery or non-rechargeable batteries to replace the

rechargeable batteries. When the headphones are not in use, switch OFF the

headphones to avoid damaging the batteries.

** The batteries must be fully charged before first use. An initial 5 hours charge is

required to guarantee an acceptable service life for the rechargeable batteries. Always

ensure that the headphones are switched to the OFF position while the batteries are

charging.

** Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference that

may cause undesired operation of the device.

PDF created with pdfFactory trial version www.pdffactory.com