Owner's Manual
4
|
Electric Guitar Amps
G25 & G50 Owner’s Manual
|
5
Connect your guitar here. If using any eects
pedals, connect your guitar to those, and then
connect the output from the last pedal to this
jack.
Sets volume for the wide-open clean BLUE
CHANNEL.
Selects Channel 1 (blue LED is lit) or Channel
2 (red LED is lit). Disabled while rear panel
CHANNEL SELECT FOOTSWITCH jack is
connected.
Select one of the 4 voices for Channel 2 here,
then turn knobs to the right to adjust sound and
volume.
Turn to minimum for cleanest sound for selected
voice, turn up to increase drive and distortion.
Does not aect BLUE CHANNEL.
Sets volume for Channel 2. Does not aect
BLUE CHANNEL.
These knobs adjust tone, aecting both
channels. For the standard tuning, turn the
knobs so the white lines are pointing straight up.
Turning a knob lower reduces that tone range.
Turning higher increases it.
Connect audio cable from smartphone, laptop
or other source.
Press On/Pair for one second to activate
Bluetooth pairing. Press O to disable Bluetooth.
Blue LED flashes when pairing, and lights solid
when paired.
Connect earbuds or headphones here, speaker
will be disabled.
Connect included power cable from power outlet
to this power jack, and flip switch on. If amplifier
will not power on and you suspect its fuse may
have blown, turn o the power switch, unplug
the power cord from the amplifier and open the
fuse compartment under the power jack using a
small flat blade screwdriver. If metal strip in fuse
is broken, replace with fuse type indicated on
rear panel.
.
Connect a latching footswitch here for channel
select control. Front panel 1/2 (Channel Select)
switch is disabled while footswitch is connected.