Operation Manual

Installation

Handling - Loudspeakers are relatively delicate, precision

engineered products that can be damaged by inappropriate

handling. Please take care when unpacking or moving them

not to touch any of the drivers. Damage to a driver will at

best degrade performance and at worst result in complete

failure.

Set Up - Radiance one - Ideally the Radiance ones should be

mounted on dedicated speaker stands tall enough to place

the tweeter at, or slightly above ear level from a seated listening

position. The use of wall mounting via brackets or shelf/cabinet

placement are viable alternatives, though performance in these

locations may be reduced from the optimum.

Radiance two/three - As oorstanding speakers both models

require placement clear of room boundaries and should be

mounted on spiked feet (supplied) for best performance. If

spikes are inappropriate for your oor covering, metal

protection pads, coins for example, may be used between the

spike and the oor.

Radiance centre - For use in home theatre systems either

directly above or below the screen. The centre can be stood

on a furniture unit (using supplied rubber feet), integrated

within a screen stand, mounted on a dedicated speaker stand

or on a wall using appropriate bracket hardware.

Connecting

Each Radiance Series speaker has two pairs of binding-post

terminals. These terminals can accept either stripped wire, spade

connectors, or 4mm plugs. Each of these termination methods are

potentially equally eective and the choice is likely to be inuenced

by the type of speaker cable used. Your dealer, distributor or cable

manufacturer will be able to oer advice.

The two pairs of binding posts are mechanically joined via gold-

plated bridging links and can be single or bi-wired.

Single-wiring

Simply connect the speaker cable to the correct polarity terminal on

the speaker (positive - red, negative - black). Either top or bottom

terminals can be used. Ensure the speaker cable is attached to the

amplier in the correct polarity before use. (Note - you will have two

unused terminals, one red, one black on the speaker when wired this

way, this is correct when the bridging links are in place)

Bi-wiring

To bi-wire you will need to unscrew the caps on the binding posts

and remove the bridging links before connection. There are multiple

ways to bi-wire/bi-amp a speaker, consult your Hi-Fi dealer for the

best advice on how to do this with your particular system. They will

also be able to advise on cable choice to best match your system.