User manual

30
8. Click Status from the left menu to view the
current connection status.
9. Click Wireless from the left menu to view the
wireless settings. The SSID shows here must
match the SSID of the radio.
• A quick way to check the SSID on the radio:
press , select Settings, select Network
Setup, and then select Connection Info.
• This screen also shows the Wireless channel
that the Enabler is broadcasting on. The
default Channel number is set to Auto. In
some cases, if there are other wireless
networks operating in near proximity on the
same channel, the Auto channel mode may
not work as expected and Auto may need to
be changed to another channel. In the above
example the channel was changed from Auto
to Channel 6.
10. To view the Wireless Security configuration,
click Configure on the Wireless screen.
• In order for the W-Fi Enabler to communicate
with the Radio, 1) SSID, 2) Wireless Security
Type, and 3) Passphrase must match on both
the AR Wi-Fi Enabler and the radio.
• The SSID on the Enabler can be found on the
white label on the side of the Enabler.
• A quick way to check the SSID on the radio:
press , select Settings, select Network
Setup, and then select Connection Info.
• The wireless security type on the Enabler
should be set to WPA-PSK. This security type
must match the security type on the radio
(WPA). Refer to page 27-28 for more
information.
• The Passphrase can be found on the white
label on the side of the Wi-Fi Enabler and it
needs to match the password/key on the
radio. Refer to page 27-28 for more
information.
More information