User`s manual

www.acousticamplification.com
8
  
  
  
4. Gain controlset so clip indicator is not lit, otherwise distortion may occur.
  set to your desired volume level. If distortion occurs, reduce volume level.
  

  
  
9. Active controlcentered around 350 Hz.
10. Active high controlcentered around 800 Hz.
11. Active high frequency controlcentered around 2 kHz.
12. Active high frequency controlcentered around 5 kHz.
 
 
1
2 43 13 6 7 8 9 10 11 12 13 145
B600H
1
43
2

load, parallel.

will allow a signal to be sent to an external effects device or equalizer, then
patched back in before the power amp section.


4. Ground Lift Switch: Lifts ground on pin 1 on XLR.
B200H
REAR PANEL LAYOUT