Operation Manual

Each effect interface will have the same controls on the top of the effect window which allow you to choose a new
preset, save a preset or delete a preset.
Active Checkbox
This determines whether or not the effect is muted or heard. If it's unchecked, it is muted and is bypassed.
Preset Drop Down
Choose a preset. If the preset is factory default, it may have [Sys] at the start of the preset name.
Load VST Preset File (VSTs or VSTi's only)
Some VST effect and instrument manufacturers will distribute additional banks of sounds, in the form of .fxb files.
These files replace your current presets with a new set of presets, given your effect or instrument a whole new range
of sounds.
To load a preset file, click the 'Load VST Preset File' button. Locate the .fxb file on your hard drive and select it, then
press OK. The .fxb file will then load into your instrument or effect, and your preset list should change.
The .fxb file you select must be designed specifically for the VST instrument or effect that you are using. If the file you
select is incompatible, an error message will be displayed.
Save New Preset
The disk icon allows you to save or re-save a preset. Change the values of the effect parameters and click this to
create your own preset.
Delete Preset
Click the X button to delete the current preset. (You can only delete presets that you've created.)
Automating Effect Parameters
Each effect has parameters or values that can be automated or changed over time.
For example, you can change the amount of flanger over time. To do this, add the "Acoustica Flanger" effect to a
track.
Then click the track header's "Toggle Automation" button to show the automation lane.
Choose the effect parameter you'd like to automate. In this case, we choose 'Feedback'