Operation Manual

Playback Position Display
This is the green readout that shows the current playback indicator time or measure and beat position. In addition, the
display will show the current tempo, time signature and key.
Loop Playback Mode
In some cases, you might want to repeat playback of a section of audio. For example, if you are practicing a part
before recording or adjusting effects on a section, you might want to continuously play a selected section of audio.
This should not be confused with looping sounds, though.
To loop playback of a section of the project, click the Loop Playback Mode icon on the Master Bar and it will
become highlighted in yellow . Click the Master Bar's Play button and it will play the selected loop area until you hit
Stop.
The loop area will be highlighted and the non-loop area will be shaded. Adjust the Loop Start and Loop End handles
to change the active loop.
To turn off Loop Playback Mode, click the Loop Playback Mode icon again .
Alternatively, you can select the Mix menu and select Loop Playback Mode to set the looping area.
You cannot record in Loop Playback Mode
(This should not be confused with looping sounds.)
Master Volume
The master volume on the Master Bar adjusts the level of the entire mix. Move the slider left or right to set the desired
volume. Alternatively, you can right click on the Master Bar and select Master Volume or choose the Mix menu
followed by clicking Set Master Volume followed by picking a level % or specifying an exact value.
Changing Master Volume Over Time
If you want to change the volume over time automatically, you can show the Master Track and then add some volume
automation points. More on automation...
Timeline
The timeline displays in time or beats mode. It also contains markers which includes tempo changes, key changes
and time signature changes.
This shows a timeline in measures and beats mode.
Click on an area for more details.