Use And Care Manual

Premium® or LePage® PL Premium®. Carefully read and follow manufacturer’s directions for
the adhesive. Be sure to allow the adhesive 24 hours to set-up. See below for additional
information.
What do I do if my substrate is bumpy or uneven and a tile pops off?
Occasionally, even after properly preparing the substrate, the surface can still have bows, high
spots, ridges or uneven areas. One way to test the area of the substrate where the tile is to be
applied is to place a tile (with the back liner unpeeled) on the area to see if it “rocks” or if it has a
solid, flat foundation. If proper adhesion is difficult or impossible, a tube adhesive can be applied
to the back of the tile to allow good adhesion. The recommended adhesive is Loctite® PL
Premium® or LePage® PL Premium®. Carefully read and follow manufacturer’s directions for
the adhesive. Be sure to remove the release film on the back of each tile before applying
additional adhesive. Apply no more than about five pea-sized dots of adhesive to the back of a
full tile. Keep the adhesive a half-inch from the edges. Press the tiles into place. If adhesive
squeezes out around the tiles, be sure to wipe it off before it dries.
What are the recommended tube adhesives that can be used if a tile pops up?
The recommended adhesive is Loctite® PL Premium®, Locktite Fastgrab®, or LePage® PL
Premium®. Carefully read and follow manufacturer’s directions for the adhesive.
What are the reasons a tile may fall off?
Improper substrate preparation
Bumpy, wavy surface
Can grout be used when working with Aspect tiles?
A sand-less grout can be used. A grout containing sand is not recommended as the grout may
scratch the surface of the tile in the cleanup process. If you want a grout-line look, colored or
white silicone caulking will have the same effect and is easier to apply and at the same time
providing a water-tight seal. Be sure to remove excess caulk or grout before it dries.
Can Aspect be exposed to UV Rays and outside elements?
No. Aspect Peel and Stick backsplash tiles are manufactured for indoor use only.
Can Aspect be exposed to heat?
Aspect has a heat index of 150 degrees (F) without causing any damage to the tile or panel. Refer
to your stove (or other heat source) manufacturer for specific information.
Will heat impact the adhesive bond on the tiles?
The adhesive will not be affect by temperatures of 150 degrees (F) or less.