Owner`s manual

10
• After 5 seconds, signal sounds. Display shows
“PROGRAM”.
3. Press 3 pad to select memory pad.
• Display shows cooking time, “STAGE 1” and
power level if other than 100 percent
power.
4. Press 3 and 0 pad to enter desired
cooking time.
5. Press POWER LEVEL pad to change
power level.
• Display shows cooking time and
current power level if other than 100
percent power.
6. Press 8 pad to enter desired power
level.
Note: Press POWER LEVEL twice to reset
to 100% power.
7. Press START pad to save new cooking
time and power level in oven memory.
• Display shows “PROGRAM”.
• Repeat step 3–8 to program
additional pads.
8. Press STOP/RESET pad or close
oven door to exit programming mode.
Double Pad Programs
The oven control can be changed to store
up to 100 cooking programs. See the
“User’s Options” section of this manual to
change oven control.
To create a double pad program, follow the instructions
above except for a change to step #3. When entering
the cooking program number, press 2 memory pads.
For example, press pads 0 and pad 3 to create a new
cooking program.
Multiple Cooking Stages
Follow instructions below to program
oven to perform four consecutive cooking
cycles without interruption. Example:
Program third cooking sequence to heat
for 30 seconds at 80% power, 40 seconds
at 50% power, and 10 seconds at 100%
power.
1. Open oven door.
• Display shows “READY”.
• If door is closed or STOP/RESET
pad is pressed before nishing
programming sequence, oven exits
programming mode.
2. Press pad 1 for approximately 5
seconds.
• After 5 seconds, signal sounds.
Display shows “PROGRAM”.
4. Press 3 pad to select memory pad.
• Display shows “P03”briey then
cooking time, “STAGE 1” and power
level if other than 100 percent
power.
5. Press 3 and 0 to enter desired
cooking time.
6. Press POWER LEVEL pad to change
power level.
• Display shows “% MW POWER”
and current power level if other than
100 percent power.
7. Press 8 pad to enter desired power
level.
8. Press TIME ENTRY pad.
• Display shows cooking time, and
“STAGE 2” indicating programming
stage 2 and power level for stage
shown in display.
• Repeat steps 5–8 to create
additional stages.
9. Press START pad to save new
cooking time and power level in oven
memory.
10. Press STOP/RESET pad or close
oven door to exit programming mode.
Programming
STYLE 1