Full Product Manual

9.
9
Using PVC purple primer and PVC cement, attach as many
sections of rigid 1 in. and 1-1/4 in. PVC pipe and couplings
(not included) as needed to connect the 1-1/4 in. male PVC
adaptor and the 1 in. female PVC adaptor to the 1 in. and
1-1/4 in. PVC elbows.
10.
10
Wrap thread tape around threads of a 1 in. discharge tee
(not included). Using a pipe wrench, thread the 1 in.
discharge tee into top of the pump (A).
Ensure the pipe slopes slightly toward the well (to prevent
air trapping in the pipe).
NOTE: It is strongly recommended that a Pressure
Regulator Kit (not included) be used instead of a regular tee.
This will help to regulate fluctuations in water pressure that
can commonly be found in deep well jet pumps. Failure to
use this item may result in a loss of prime and/or irregular
water pressure.
Proceed to the FINAL INSTALLATION INSTRUCTIONS below.
FINAL INSTALLATION INSTRUCTIONS
1.
1
Wrap thread tape around the threads of a 1 in. male PVC
adaptor (not included), and thread the adaptor into the
discharge tee (or Pressure Regulator).
2.
2
Wrap all threads with thread tape. In order for the pump (A)
and the pressure tank (not included) to operate properly, the
pressure tank needs to be drained of all water BEFORE
INSTALLING IT TO THE PUMP. Thread a 10 in. tank tee (not
included), or another necessary size tee into the diaphragm
of the pressure tank.
Plug one outlet on top of the tank tee with a 1/4 in. plug and
install a pressure gauge (not included) on the other outlet on
top of the tank tee. Thread two 1 in. female PVC adaptors (not
included) into the two inlet sides of tank tee. Thread a 1/2 in.
relief valve (not included) and a 1/2 in. drain valve (Item not
included) to the front of the tank tee.
These final steps are the same for both shallow well and deep well application.
A
A
A