Instruction Manual

Artex Products / ACR Electronics, Inc. 570-0023 Rev. G
Page 16 of 33
6.3 Panel Cutout Instructions
6.3.1 Select a mounting location where the remote switch can be seen from the pilot’s seated
location, easily be reached by the pilot, out of direct sunlight, and can accommodate the
remote switch and the label. Depending on the remote switch orientation on the control
panel, choose the appropriate label and discard the other one. Label 591-0003 and label
591-3029 are provided in the 455-0023 pack list.
Figure 5: Labels 591-0003 & 591-3029
6.3.2 Create a cutout in the panel for the remote switch according to the minimum
dimensions specified below and drill four 1/8” diameter holes. The dimensions apply to
both 591-0003 and 591-3029 labels. Adjust the hole-pattern appropriately on the panel
depending on the orientation of the remote switch.
NOTE: For Ameri-King retrofit applications, use the existing mounting holes since the
face plate of the remote switch is designed to accommodate that hole-pattern.
Tolerance: +.020, -.000
Figure 6: Panel Cutout Dimensions