Instruction Manual

Artex Products / ACR Electronics, Inc. 570-0023 Rev. G
Page 18 of 33
7. INSTALLATION
7.1 Instructions
7.1.1 Feed the modular jack connector from the harness through the panel cutout.
7.1.2 Plug the modular jack connector to the remote switch.
Figure 7: Harness to Remote Switch Connection
7.1.3 Slide the remote switch and the harness inside the cutout following the orientation
shown below.
7.1.4 Secure the remote switch using the hardware provided in the 455-0023 pack list. Use a
1/16 hex socket for the nuts and a small Phillips screwdriver for the screws. The torque
on the screws is 4.0 Lb-in (± 0.5 Lb-in).
Figure 8: Remote Switch Orientation