Instruction Manual

Artex Products / ACR Electronics, Inc. 570-0023 Rev. G
Page 23 of 33
10.3.2 Carefully remove the cell 131-0001 from the plastic cell holder and keep the conical
spring.
Figure 12: Conical Spring
10.3.3 Dispose of the cell according to the instructions specified in section 10.6.
10.3.4 Carefully slide the replacement cell 131-0001 inside the plastic cell holder following the
polarity mentioned inside the holder and on the cell, or by matching the positive (+) end
of the cell to the red wire side of the holder.
10.3.5 Install the conical spring between the positive side of the cell and the cell holder.
10.3.6 Push the cell against the conical spring.
Figure 13: Conical Spring Installation
Spring