Instruction Manual

Artex Products / ACR Electronics, Inc. 570-0023 Rev. G
Page 26 of 33
10.4 Cell Replacement from Cell Holder with Built-in Spring
10.4.1 Carefully remove the cell 131-0001 from the plastic cell holder.
10.4.2 Dispose of the cell according to the instructions specified in Subsection 10.6.
10.4.3 Carefully slide the negative end of the replacement cell 131-0001 inside the plastic cell
holder following the polarity mentioned inside the holder and on the cell, or by matching
the positive (+) end of the cell to the red wire side of the holder.
Figure 16: Cell Installation
10.4.4 Pull the built-in spring away from the end of the cell using tweezers and slide the cell
inside the holder.
Figure 17: Spring Installation