Manualshelf

User guide

ManualsBrandsACR&Artex ManualsSensorsME406 Portable ELT
21222324252627282930
ARTEX PRODUCTS / ACR ELECTRONICS, INC
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
ME406P (453-6611)
25-62-31
Page 28 of 85
JUN 25/13
(7) A tether assembly is attached to the ELT; however, the ELT is not buoyant on its own and a
flotation device is required for deployment in water.
Figure 8. ME406P Portable Configuration
SUBTASK 25-62-31-870-005
E. ELT Reset
(1) If the ELT is activated accidently, it will need to be reset.
(2) Reset the ELT from the cockpit by moving the remote switch to the “ON” position, waiting
approximately one second, and then moving it back to the “ARM” position. If the switch is
already in the “ON” position, move it to the “ARM” position.
(3) Reset the ELT locally by moving the switch on the ELT to the “ON” position, waiting
approximately one second, and then moving it back to the “ARM” position. If the switch is
already in the “ON” position, move it to the “ARM” position.
NOTE
: The ELT cannot be reset if either the cockpit remote switch or the ELT local switch is
in the “ON” position.
SUBTASK 25-62-31-750-001
F. Functional Check
(1) A monthly functional check is recommended to verify operational status of the ELT.
(2) Perform this functional check in accordance with SUBTASK 25-62-31-750-011 on page 41.