Operation Manual

Installing your certificate to your Windows certificate store

1. On the server, click Start, and then click Run.

2. In the Open box, type mmc, and then click OK.

3. On the File menu click Add/Remove snap-in.

4. In the Add/Remove Snap-in dialog box, click Add.

5. In the Add Standalone Snap-in dialog box, click Certificates, and then click Add.

6. In the Certificates snap-in dialog box, click Computer account (this is not selected by default),

and then click Next.

7. In the Select Computer dialog box, click Local computer: (the computer this console is running

on), and then click Finish.

8. In the Add Standalone Snap-in dialog box, click Close.

9. In the Add/Remove Snap-in dialog box, click OK.

10. In the left pane of the console, double-click Certificates (Local Computer).

11. Right-click Personal, point to All Tasks, and then click Import.

12. On the Welcome to the Certificate Import Wizard page, click Next.

13. On the File to Import page, click Browse, locate your certificate file, and then click Next.

Note: If you are importing a PFX file, you will need to change the file filter to “Personal Information

Exchange (*.pfx, *.p12)” to display it.

14. If the certificate has a password, type the password on the Password page, and then click Next.

15. Check the following boxes:

a. Mark this key as exportable

b. Include all extended properties

16. On the Certificate Store page, click Place all certificates in the following store, and then click

Next.

17. Click Finish, and then click OK to confirm that the import was successful.

All of the certificates successfully installed in the Windows Certificate Store will be available when

using the Acronis Access Configuration Utility.

Configure Acronis Access to use your certificate

After you've successfully installed your certificate to your certificate store, you have to configure

Acronis Access to use that certificate.

1. Launch the Acronis Access Configuration Utility.

Note: Located in C:\Program Files (x86)\Acronis\Access\Configuration Utility by default.

2. Select your certificate from the Certificate selector on the Gateway Server and Access Server

tabs.

3. Click Apply.

The web services will restart and after about a minute they should be running with your certificate.