Operation Manual

2. You will be asked if the existing network address for the server you are registering can be used to

directly access the server. The existing address is typically the network address that your mobile

device users must use to access the Gateway Server, so it’s possible this address points to a proxy

server or load balancer.

Note: If this is the case, you need to select “No” at this dialog and enter an alternate network address

that will be used by the Acronis Access server to gain direct network access to this Gateway Server

3. You will then be presented with the registration dialog.

Note: If your Gateway Server is using a self-signed SSL certificate, you will need to enable “Allow

connections from Acronis Access servers using self-signed certificates”.

Note: You will also need to enter an Administration Key, to enable the pairing with this remote server.

This is done to validate and secure the administrative relationship.

4. To obtain an Administration Key from your Gateway Server, open a new browser window or tab

and navigate to the Gateway Server’s HTTPS address. This should be the same address that is