User Guide

ManualsBrandsAcronis ManualsOtherBACKUP RECOVERY 10 ADVANCED SERVER

331

332

333

334

335

336

337

338

339

340

Specifies whether the machine where the Acronis Backup & Recovery 10 component is installed

will participate in the Customer Experience Program.

Select one of the following:

Not Configured

By default, the machine does not participate in the Customer Experience Program.

Enabled

In Enable sending reports to Acronis, select one of the following:

Enable

Information about the hardware configuration, the most and least used features and about

any problems will be automatically collected from the machine and sent to Acronis on a

regular basis. The end results are intended to provide software improvements and enhanced

functionality to better meet the needs of Acronis customers. Acronis does not collect any

personal data. The terms of participation can be found on the Acronis Web site.

Disable

The information will not be sent.

Disabled

The same as Not configured.

7.2.2 Parameters set through GUI

The following parameters can be set through the graphical user interface (GUI):

 For Acronis Backup & Recovery 10 Management Server: Collecting Logs, Windows Event Log,

SNMP, SNMP Address, and SNMP Community

 For Acronis Backup & Recovery 10 Agent: Windows Event Log, SNMP, SNMP Address,

SNMP Community and Customer Experience Program

You will find the description of these parameters in the correspondent topic about configuration

through the administrative template.

7.2.3 Parameters set through Windows registry

The following two parameters determine paths to Acronis Backup & Recovery 10 Storage Node's

internal databases, which contain information about managed vaults. They can be modified only by

editing the registry.

When to modify

While the database located in the folder determined by DatabasePath is typically small, the tape

database, located at TapeDatabasePath, may be large if the tape library contains thousands of

archives, and you may want to store the tape database on a volume other that the system volume.

Parameters

Important: We do not recommend modifying these parameters. If you do need to modify either of them, you

should do this before creating any correspondent (tape or non-tape) managed vaults. Otherwise, the storage

node will lose access to those vaults until you re-attach them, and re-attaching a vault—especially a

deduplicating one—may take a considerable amount of time.

DatabasePath

Description: Specifies the folder where Acronis Backup & Recovery 10 Storage Node stores its

non-tape vaults database.