11.0

11 Copyright © Acronis, Inc., 2000-2011
Without this parameter, the agent will run under the default account: Acronis Agent User
/cep_enabled
Specifies whether the machine will participate in the Customer Experience Program.
With this parameter, information about the hardware configuration, the most and least used
features and about any problems will be automatically collected from the machine and sent to
Acronis on a regular basis. The terms of participation can be found on the Acronis Web site.
Without this parameter, the information will not be sent.
Parameters that apply only to a component that requires a license
The following parameters apply only to the installation packages AcronisAgentWindows.msi,
AcronisBootableComponentsMediaBuilder.msi, and AcronisUniversalRestore.msi (except the
/online_backup parameter).
/serial <License key>
Specifies the license key to use when installing the component. A license key is a sequence of
letters and numerals separated by dashes. Enter the license key exactly, including the dashes.
/old_serial <Old license key>
When upgrading from Acronis Backup & Recovery 10 (ABR10), specifies the license key for
that product. Use this parameter with the /serial parameter.
/online_backup
Specifies that the component will be installed for online backup only. A license key is not
required.
Note: Specify either the /serial parameter or the /online_backup parameter, but not both.
Parameter that apply only to the management console
The following parameter applies only to the installation package
AcronisStandaloneManagementConsole.msi.
/current_user
Specifies that the component will be installed for the current user only, rather than for all users
on a machine.
2.6 Update
To update one or more Acronis Backup & Recovery 11 components:
1. Run the setup program of the updated version of Acronis Backup & Recovery 11.
2. Click Install Acronis Backup & Recovery 11.
3. Click Update.
4. If prompted, type the product license key.
5. Follow the on-screen instructions.
Updating components in the unattended mode
For information about updating a component in the unattended mode, see "Unattended installation
(p. 8)".