Operation Manual

5.1.2.1 Partition properties

When you recover partitions to a basic disk, you can change properties of these partitions. To open

the Partition Properties window, click Properties next to the selected target partition.

You can change the following partition properties:

 Letter

 Label

 Type

You can make the partition primary, primary active, or logical.

 Size

You can resize the partition by dragging the right-side border with your mouse, on the horizontal

bar on the screen. To assign the partition a specific size, enter the appropriate number into the

Partition size field. You can also select the position of unallocated space—before or after the

partition.

5.1.3 About recovery of dynamic/GPT disks and volumes

Recovery of dynamic volumes

You can recover dynamic volumes to the following locations on the local hard drives:

 Dynamic volume.

Manual resizing of dynamic volumes during recovery to dynamic disks is not supported. If you need to resize

a dynamic volume during recovery, it should be recovered to a basic disk.

 Original location (to the same dynamic volume).

The target volume type does not change.

 Another dynamic disk or volume.

The target volume type does not change. For example, when recovering a dynamic striped

volume over a dynamic spanned volume the target volume remains spanned.

 Unallocated space of the dynamic group.

The recovered volume type will be the same as it was in the backup.