7.0
Table Of Contents
- END-USER LICENSE AGREEMENT
- Introduction
- Installation and operation
- General program information
- Creating a partition (disk) image
- Restoring a disk (partition) from an image
- Browsing and restoring individual files
- Transferring the system to a new disk
- Adding a new hard disk
- Scheduled tasks
- Other operations
- Troubleshooting
- Partitions and file systems
- Hard disks and BIOS setup
Acronis True Image User’s Guide
Copyright © SWsoft, 2000–2003
77
ROM PCI/ISA BIOS (2A69JA2A)
STANDARD CMOS SETUP
AWARD SOFTWARE, INC.
Date (mm:dd:yy) : Fri, May 15 1998
Time (hh:mm:ss) : 11: 33: 53
HARD DISKS : TYPE SIZE CYLS HEAD PRECOMP LANDZ SECTOR MODE
Primary Master : Auto 0 0 0 0 0 0 Auto
Primary Slave : Auto 0 0 0 0 0 0 Auto
Secondary Master : None 0 0 0 0 0 0 0
Secondary Slave : None 0 0 0 0 0 0 0
Drive A : 1.44 M
Drive B : None Base Memory: 0K
Extended Memory: 0K
Video : EGA/VG Other Memory: 512K
Halt On: All Errors Total Memory: 512K
ESC : Quit ↓→←: Select Item PU/PD/+/- : Modify
F1 : Help (Shift) F2 Change Color
The Type parameter can have Auto, Not Installed or User Defined values. In the
latter case, you have to specify the values of other parameters manually (except
MODE) according to the information on the case of the hard disk.
The purpose of the MODE and LANDZ parameters is described in the note above. The
PRECOMP parameter is the so-called precompensation parameter and is important only for
the older hard disks (MFM and RLL). IDE disks ignore this parameter.
In earlier BIOS versions, the boot sequence was set in the BIOS FEATURES setup
section in the Boot Sequence line where you could select the most typical boot
sequences, for example C:; A:;CD-ROM: or CD-ROM:; C:; A:, and other.
B.2.5 Hard disk initialization errors
Devices are usually initialized successfully, but sometimes errors can happen. Typical
errors related to hard disks are reported by the following messages:
PRESS A KEY TO REBOOT
This error message is not directly related to errors during hard disk initialization.
However, it appears, for example, when the boot program finds no operating
system on the hard disk, or when the primary partition of the hard disk is not set as
active.
DISK BOOT FAILURE,
INSERT SYSTEM DISK AND
PRESS ENTER
This message appears when the boot program finds no available boot device, be
that a floppy or a hard disk, or a CD-ROM.
C: DRIVE ERROR
C: DRIVE FAILURE