Operation Manual

Note that if the existing machines are running, then for the successful recovery operation you should

either stop them manually or select the Power off target VMs when starting recovery option in the

recovery options dialogue (see "VM power management" section (p. 48)).

When choosing the Create VMs with different names option the restored VMs will be named

according to the following convention:

“[Original_VM_name]_DATE”.

Where “Original_VM_name” is the initial name of the restored virtual machine, and DATE is the

current date. For example if the restored VM was called “VM_original” then after recovery it will be

named “VM_original_05/25/2011”.

After you completed the selection of “Where to restore”, click Next to finish the second step and

proceed to the last one.

8.3 How to restore

In the third step of the restore backup task wizard, you should define the preferences of your

recovery task.

Here you can specify whether to validate the archives before the recovery (for further information on

Backup validation, please refer to "Validating backups" section (p. 85)). Also, here you can adjust the

settings for your recovery task by clicking the More options… link.

New Restore Task wizard, Step 3 “How to restore”

To complete the wizard and create the restore backup task you must set up the task name and define

how to run it. Note that [ ] { } ; , . symbols are not allowed for the task name.