Operation Manual

8.4.3 VM power management

Power on target VMs when recovery is finished

This option allows configuring the virtual machines power management after executing the restore

backup task.

After a machine is recovered from a backup to another machine, there is a chance that the existing

machine's replica will appear on the network. For a safe operation, power on the recovered virtual

machine manually, after you take the necessary precautions.

This option is disabled by default. Select the Power On target VMs when recovery is finished check

box for starting up the virtual machine automatically.

8.4.4 Additional Settings

Use FTP in active mode

It is possible to use FTP active mode for FTP authentication and data transfer. The default setting for

Use FTP in active mode is disabled.

Enable this option if your FTP server supports active mode and you want this mode to be used for file

transfers.

After you finished with all the settings, click OK to close the pop-up and apply them for the current

restore task only.

8.4.5 Exchange Server Restore Settings

Prior to running Exchange Server Backup Extraction you have to configure the Default Exchange

extracting settings. Extracting of mailboxes or mailbox contents requires temporary mounting of a

specific VM from the backup. Go to Exchange settings tab and specify the VM mounting parameters.

 ESX(i) host.

 Resource Pool.

 Datastore.

8.5 Managing created restore task

When editing an existing restore task you will see all the sections (steps) of the wizard you completed

while creating you restore task. All three steps of the wizard will appear on the screen at once. (For

further information, please refer to “Managing Tasks" section (p. 75)).