Operation Manual

You can select the desired location by expanding the appropriate folder group and choosing it in the

folder tree or by entering the full path to the location in the Location field.

Choose one of the backup location types from the browse tree on the left side. If the selected

location (Online backup storage, Network folders or FTP/SFTP servers) requires an authentication,

you will first see the dialogue for submitting your credentials in the right pane. After successfully

logging in, this pane shows the contents of the selected location, i.e. the archives inside this location.

An alternative to browsing the location in the tree is entering the path in the corresponding Location

field below and clicking the Go button to explore this location. In this case, you will also see the same

authentication dialogue in the right pane where you are asked to enter your login and password.

You have to select or specify the path in the Location field in order to complete the wizard, and then

click OK. The OK button is grayed out until there is a valid location selected.

16.2 Virtual Machines catalog

The middle section of the Recovery Points view presents the Virtual Machines catalog. This tree list

of virtual machines and vApps is built based on parsing through the archives found in the location

selected in the left section.

If the selected location contains any password-protected archives or archives of physical machines,

they are shown in the separate list under the Encrypted and Physical machines Data. To view the

contents of these archives, you have to specify the password in the Password pop-up.