Owner's manual

V1.3 Operation Manual, Xymba XB47/57
© 2010, Acronova Technology, Inc. 15
SOFTWARE INSTALLATION
Xymba requires a device driver to be installed before it can work
properly with the application software. Before starting the application
software installation, the device driver must be installed.
System Requirements
Microsoft® Windows XP, Vista, 7
Pentium III 700Mhz (Pentium IV 1.6Ghz Recommended)
512MB RAM (1GB RAM Recommended)
1024x768 display with 16-bit video card
Optical disc drive (to install the device driver and software from
the installation disc)
USB 2.0 interface
Device Driver Installation
Follow the steps below to complete Xymba’s device driver installation:
1) Connect the power cord to Xymba and a wall outlet.
2) Turn the power switch to the On position.
3) Turn Xymba on. Wait patiently until the installation is complete
and the Ready LED is steady green.
4) Turn on the host computer, which is connected to Xymba via USB
cable.
5) Insert the provided installation CD into your CD/DVD drive.
6) Connect the USB cable to both Xymba and your PC.
7) Windows will inform you that it has found new hardware. Browse
to the installation CD and choose ACAL764.inf as the device
driver.
8) If the Windows System doesn’t show the “Found New Hardware”
message window, you can go to Windows Device Manager and
install the autoloader driver manually.
You may now proceed to install the application software. Refer to the
user’s manual that came with the software for installation instructions.
Note:
Go to the Device Manager in Windows Operating System
to verify that the device driver has been successfully
installed.