Owner's manual

Operation Manual, Xymba XB47/57 V1.3

Turning Xymba On

Follow the steps below to get your Xymba ready:

1) Connect the power cord to Xymba and a wall

outlet.

2) Turn the power switch to the On position.

Connect the USB cable to both Xymba and your PC.

Xymba will enter the initialization process and will remove any discs

inside the optical recorders. Please be patient until the initialization

process has completed.

When initialization is complete, you will see the “ready” indicator light up

signaling that Xymba is ready to start a disc operation.

Important:

The Finish Disc Bin or Output Ramp must be in position during

operation. Removing the Finish Disc Bin or closing the Output

Ramp will stop Xymba from operating immediately after the active

disc has completed writing.

Turning Xymba Off

To turn Xymba off, turn the power switch to the Off position. In case

there is a session underway, abort or wait until it has completed.

Although it is fine to leave the power cord plugged in, it is

recommended that you unplug the cord for increased safety when

Xymba is not used for extended periods of time.