Hardware manual

20
Wand port
The Wand port is located on the lower left corner of the terminal.
It is a 6-pin DIN port which will accept a circular DIN connector.
The Wand, when connected, uses only 3 of the 6 pins available on
the DIN connection. If a Bar Code Gun (non-contact reader) is
used, the center pin supplies additional power. The terminal uses
2 of the remaining pins as logic lines for external controls. See
pin-out and function table below:
Pin Function
1 +5 Volts
2 Signal control logic line (special)
3 Bar Code Wand receive data
4 GND
5 Access logic line (special)
6 9 Volt unregulated
(maximum current draw 220 mA)
W
W
AND
AND
RS
RS
485
485
RS
RS
232
232
9V
9V
1
2
3
4
5
6
END VIEW
6-pin DIN jack
Ports and connections