Owner's manual

Revision: 1.0
44
98h Reserved REEL B Steps
9Ch Reserved
A0h REEL C Lamp REEL C Feedback Pattern REEL C Status
A4h REEL C Running Steps REEL C Timing
A8h Reserved REEL C Steps
ACh Reserved
B0h REEL D Lamp REEL D Feedback Pattern REEL D Status
B4h REEL D Running Steps REEL D Timing
B8h Reserved REEL D Steps
BCh Reserved
C0h REEL E Lamp REEL E Feedback Pattern REEL E Status
C4h REEL E Running Steps REEL E Timing
C8h Reserved REEL E Steps
CCh Reserved
D0h REEL F Lamp REEL F Feedback Pattern REEL F Status
D4h REEL F Running Steps REEL F Timing
D8h Reserved REEL F Steps
DCh Reserved
Note: ACE-B2019 AGC supports I/O ports from port A to port J, it does not supports reel
control function.
SRAM Bank Select (00h)
Bit Field Description
Software
Readable
Software
Writable
Value after
Reset
0
SRAM mode select.
‘0’ = > Independent mode. You can use memory base
address FDB00000~FDBFFFFF total 1024KB space.
‘1’ = > replicate mode. Write data in the base address
FDB00000~FDB7FFFF total 512KB space, you can read
same data in the FDB80000~FDBFFFFF.It had backup
function but FDB80000~FDBFFFF space is read only.
Yes Ye s 0
7 : 1 Reserved Yes Yes 0
Interrupt & Timer Enable Register (08h, 09h & 0Ah )
Bit Field Description
Software
Readable
Software
Writable
Value after
Reset
0
Port A Interrupt Enable bit. ‘0’ = No support
Interrupt from Port A as Input; ‘1’ = Support
Interrupt from Port A as Input.
Yes Yes 0
1
Port B Interrupt Enable bit. ‘0’ = No support
Interrupt from Port B as Input; ‘1’ = Support
Interrupt from Port B as Input.
Yes Yes 0
2
Port C Interrupt Enable bit. ‘0’ = No support
Interrupt from Port C as Input; ‘1’ = Support
Interrupt from Port C as Input.
Yes Yes 0
3
Port D Interrupt Enable bit. ‘0’ = No support
Interrupt from Port D as Input; ‘1’ = Support
Interrupt from Port D as Input.
Yes Yes 0