User Manual
Table Of Contents
- 1. System Introduction
- 2. Assembly/Disassembly Procedures
- 3. BIOS Settings
- 4. Function Description
- 5. Driver and Utility Installation
- 6. Software Installation and Programming Guide
- 7. FAQ
- Q 1. Why the Linux operating system can not re-install by the same storage device?
- Q 2. Why the monitor display abnormally on screen during Linux installation?
- Q 3. Why the display resolution only for 800x600 and 1024x768 at X Window under Basic Graphics Mode?
- Q 4. Does my system support Windows 8?
- Q 5. Why do we get error message when we execute utility program?
- Q 6. What can I do if my system does not power on?
- Q 7. No display when power on?
- Q 8. Where is the serial number located on my system?
- Q 9. My system has audio problem?
- Q 10. My system can not connect to Internet?
AES-HM76Z1FL User Manual
29
www.acrosser.com
3.6. Security Setup
Aptio Setup Utility - Copyright © 2012 American Megatrends, Inc.
Version 2.15.1226. Copyright © 2012 American Megatrends, Inc.
→← : Select Screen
↑↓ : Select Item
Enter : Select
+/- : Change Opt.
F1 : General Help
F2 : Previous Values
F3 : Optimized Defaults
F4 : Save & Exit
ESC : Exit
Main SecurityBoot Save & ExitChipsetAdvanced
Password Description
If only the Administration’s password is set,
then this only limits access to Setup and is
only asked for when entering Setup.
If only the User’s password is set, then this
is a power on password and must be entered to
boot or enter Setup. In Setup the User will
have Administrator rights.
The password length must be
in the following range:
Minimum length
Maximum length
Administrator Password
System Mode state
Secure Boot state
Secure Boot
HDD Security Configuration:
PO: ADATA SX900
3
20
Setup
Disabled
[Enabled]
• Administrator Password
Set administrator password.
• Secure Boot
Secure Boot ow control. Secure Boot is possible only if System runs in User Mode.