User Manual
Table Of Contents
- 1. System Introduction
- 2. Assembly/Disassembly Procedures
- 3. BIOS Settings
- 4. Function Description
- 5. Driver and Utility Installation
- 6. Software Installation and Programming Guide
- 7. FAQ
- Q 1. Why the Linux operating system can not re-install by the same storage device?
- Q 2. Why the monitor display abnormally on screen during Linux installation?
- Q 3. Why the display resolution only for 800x600 and 1024x768 at X Window under Basic Graphics Mode?
- Q 4. Does my system support Windows 8?
- Q 5. Why do we get error message when we execute utility program?
- Q 6. What can I do if my system does not power on?
- Q 7. No display when power on?
- Q 8. Where is the serial number located on my system?
- Q 9. My system has audio problem?
- Q 10. My system can not connect to Internet?
AES-HM76Z1FL User Manual
49
www.acrosser.com
Syntax: get_wdt_count()
Description:
This function read the value of the watchdog time counter.
Parameters:
None
Return Value:
This function returns the value of the time counter.
6.2.4. Hardware Monitor
Table 4. Hardware Monitor Syntax Description
Syntax: get_cpu_temp(void)
Description:
Get the CPU Temperature.
Parameters:
None
Return Value:
An Integral number.
Syntax: get_sys_temp(void)
Description:
Get the System Temperature.
Parameters:
None
Return Value:
An Integral number.
Syntax: get_cpu_core_voltage(void)
Description:
Get the CPU Core Voltage.
Parameters:
None
Return Value:
A oating number.
Syntax: get_5_voltage(void)
Description:
Get the 5V Voltage.
Parameters:
None
Return Value:
A oating number.
Syntax: get_12_voltage(void)
Description:
Get the 12V Voltage.
Parameters:
None
Return Value:
A oating number.
Syntax: get_33_voltage(void)
Description:
Get the 3.3V Voltage.
Parameters:
None
Return Value:
A oating number.