User Manual
Table Of Contents
- 1. System Introduction
- 2. Assembly/Disassembly Procedures
- 3. BIOS Settings
- 4. Function Description
- 5. Driver and Utility Installation
- 6. Software Installation and Programming Guide
- 7. FAQ
- Q 1. Why the Linux operating system can not re-install by the same storage device?
- Q 2. Why the monitor display abnormally on screen during Linux installation?
- Q 3. Why the display resolution only for 800x600 and 1024x768 at X Window under Basic Graphics Mode?
- Q 4. Does my system support Windows 8?
- Q 5. Why do we get error message when we execute utility program?
- Q 6. What can I do if my system does not power on?
- Q 7. No display when power on?
- Q 8. Where is the serial number located on my system?
- Q 9. My system has audio problem?
- Q 10. My system can not connect to Internet?
AES-HM76Z1FL User Manual
53
www.acrosser.com
• How do I connect the second monitors to my system?
• Basically, there are “duplicate” and “extend” mode for the second monitor.
• “duplicate” mode – you will see the same contents on both monitors.
• “extend” mode – your monitors display different contents, and you can drag
your contents between the rst and second monitor.
• Ensure the display device setting is correct and monitor cables are connected
well.
• For device setting, it could be different because of different operating systems
and S/W version.
• You can search from “Google” as reference setting.
• If the problem still exist, please contact Acrosser FAE or authorized sales
channels.
Q 9. My system has audio problem?
• Make sure to enable the on-board audio function in BIOS menu.
Aptio Setup Utility - Copyright © 2012 American Megatrends, Inc.
Version 2.15.1226. Copyright © 2012 American Megatrends, Inc.
→← : Select Screen
↑↓ : Select Item
Enter : Select
+/- : Change Opt.
F1 : General Help
F2 : Previous Values
F3 : Optimized Defaults
F4 : Save & Exit
ESC : Exit
LAN1
LAN2
Audio
SB USB Configuration
Graphics Configuration
Main BootChipsetAdvanced
[Enabled]
[Enabled]
[Auto]
Security Save & Exit
• Make sure the audio driver and device was installed successfully.
• Make sure the speaker is connected to the correct connector.
• Check if the audio function is set to “MUTE”.
• Please adjust the audio volume louder.