Instruction Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Procedures of Assembly/Disassembly
- Chapter 3 Board Introduction
- Chapter 4 H/W Information
- Chapter 5 BIOS Settings
- SATA Configuration
- W83627DHG Super IO Configuration
- Serial Port Console Redirection
- Intel(R) 82576 Gigabit Dual Port Network Connection
- N/A
- Configure Gigabit Ethernet device parameters
- Intel(R) 82574L Gigabit Network Connection
- N/A
- Configure Gigabit Ethernet device parameters
- SATA Mode Selection
- Port 1
- Port 2
- CF card
- COM1 Configuration
- COM2 Configuration
- LAN by Pass Function
- Change Settings
- Serial Port
- Change Settings
- Device Mode
- Console Redirection
- Console Redirection Settings
- EMS
- EMS Settings
- Terminal Type
- Bits per second
- Data Bits
- Parity
- Stop Bits
- Flow Control
- NIC Configuration
- Blink LEDs (range 0-1
- Link Status
- NIC Configuration
- Blink LEDs (range 0-1
- Link Status
- SYS temperature
- CPU temperature
- CPU Fan Speed
- VCORE
- LAN1 ~ 8
- USB Configuration
- xHCI Mode
- EHCI1
- Setup Prompt Timeout
- Boot up NumLock State
- Boot Logo
- PXE Function
Option Choice Description
Serial Port
Disabled / Enabled Enable or Disable Serial Port (COM)
Change Settings
Auto IO=3F8h; IRQ=4
/ IO=3F8h;
IRQ=3,4,5,6,7,10,11,1
2 / IO=2F8h;
IRQ=3,4,5,6,7,10,11,1
2 / IO=3E8h;
IRQ=3,4,5,6,7,10,11,1
2 / IO=2E8h;
IRQ=3,4,5,6,7,10,11,1
2
Select an optimal setting for Super IO device.
Device Mode
Standard Serial Port
Mode / IrDA Active
pulse 1.6 Us / IrDA
Active pulse 3/16 bit
time / ASK-IR Inverting
IRTX, Routed to IRRX
/ ASK-IR Inverting
IRTX &500KHz,
Routed to IRRX /
ASK-IR Inverting
IRTX, Demodulation to
IRRX / ASK-IR
Inverting
IRTX&500KHz,
Demodulation to IRRX
Change the Serial Port mode. Select <High Speed> or
<Normal mode> mode
40